Garmin 530w 用户指南

97

4.  Select “Load?” (or “Activate?”, if already on 

vectors-to-final). 

1.  Select Billard Muni (KTOP) as your destination, 

using the direct-to key or as the last waypoint 
in a flight plan. 

2.  Press the PROC key and select the “VOR 22” 

approach. 

3.  From the transitions window, select “D258G/

LEBVY” as the IAF.  Also, select “Load?”. 

 

NOTE: Since this is not a GPS approach, the pilot 
should be using the VLOC receiver, tuned to the correct 
VOR (TOP) for navigation. 

4.  When cleared, press the PROC key and select 

“Activate Vectors-To-Final?”. 

Flying the Vectors Approach

With “Vectors-To-Final” (VTF) selected, the CDI 

needle remains off center until you’re established on 
the final approach course. With the approach acti-
vated, the Map Page displays an extension of the final 
approach course in magenta (remember, magenta is 
used to depict the active leg of the flight plan) and 
“VTF” appears as part of the active leg on the Default 
NAV Page (as a reminder that the approach was 
activated with vectors-to-final). In this example, we’ll 
assume ATC vectors result in a rectangular course to 
intercept final, as follows: 









1.    When VTF is activated, the 500W-series unit 

switches from en route mode to terminal mode 
and the CDI scale transitions from 2.0 to 1.0 
nautical miles, full scale deflection. 

Vectors-To-Final Approach