Garmin 10 业主指南
4
GTM 10 Owner’s Manual
I
NSTALLING
AND
T
ESTING
Step 3: Connect to the Radio
1. Connect the antenna plug to the appropriate female
(receptacle) adapter cable. Connect the Fakra plug
to the
In connector on the GTM 10. The Fakra plug
locks firmly in place.
Fakra
connector
Female
adapter
Antenna
connector
If the antenna cable has a Fakra connector, no adapter
cable is needed between the antenna cable and the
GTM 10 In connector. Connect the Fakra antenna
cable directly into the In connector of the GTM 10.
Then use the supplied dual-ended Fakra cable to
connect the GTM 10 to the radio, as described below.
2. Connect the Fakra connector of the adapter cable to
the
Out connector of the GTM 10. Connect the male
(plug) adapter cable into the radio receptacle.
Fakra
connector
Male
adapter
Radio
receptacle
TEST: Turn on the vehicle’s radio. If you can
hear sound from an FM radio station, you have
properly connected the GTM 10.
Step 4: Route the Mini-USB Cable
Route the mini-USB cable from behind the radio on the
passenger’s side of the vehicle. If possible, thread the
cable through an existing opening in the glove box or
trim panel. Thread enough cable through the opening to
reach the GPS device. Do not cut the mini-USB cable.
If the mini-USB cable is not long enough to reach the
If the mini-USB cable is not long enough to reach the
GPS device, a 2-meter extension cable is available for
purchase from the Garmin Web site at
or from a Garmin dealer.
Step 5: Test the GTM 10
Observe the LED: With the GTM 10 connected to the
GPS device, turn on the GPS device. Service reception
is indicated by the Green solid light, which may take
up to five minutes to appear for initial data acquisition.