Viking Range veos100t 安装指导
G
Gaass B
Baakke
e B
Bu
urrn
ne
err A
Ad
djju
ussttm
me
en
nttss ffo
orr tth
he
e O
Ou
uttd
do
oo
orr O
Ovve
en
n
A properly adjusted burner should be stable and quiet. The flame should have sharp, well defined blue inner cone
with no yellow tipping. The flame should also be stable and uniform with no flames lifting off the burner ports.
1. Located the air shutter (1) and loosen the set screw (2) that holds the air shutter in place.
2. Adjust the air shutter (1) to obtain a blue flame with no yellow tipping that contacts the burner at the burner ports.
with no yellow tipping. The flame should also be stable and uniform with no flames lifting off the burner ports.
1. Located the air shutter (1) and loosen the set screw (2) that holds the air shutter in place.
2. Adjust the air shutter (1) to obtain a blue flame with no yellow tipping that contacts the burner at the burner ports.
a. Open the air shutter gap (1) to eliminate yellow tipping.
b. Close the air shutter gap (1) to prevent a noisy flame that lifts off the burner.
b. Close the air shutter gap (1) to prevent a noisy flame that lifts off the burner.
3. Light the burners by rotating the thermostat to a baking temperature. If the flame is not stable with a blue inner
cone and no yellow tipping. Turn the burner off and repeat step 2.
4. Once a staple flame is achieved, tighten the air shutter set screws. The burner flame cone should be 1/2” long
when the air shutter is correctly adjusted. NOTE: Both air shutters should be set to the same opening.
5. Replace the bottom pan and racks.
10
A
Aiirr
S
S
Sh
hu
utttte
err
B
Bu
urrn
ne
err
O
Orriiffiicce
e H
Ho
oo
od
dss
IMPORTANT!
C
Co
on
nd
diittiio
on
nss tth
haatt ccaau
usse
e o
od
do
orrss::
1. Floating flames are lazy looking and do not have well defined cones. They are long, ill-defined, quiet flames that
sometimes lift completely off the ports and cause a strong and pungent odor.
2. Lifting flames are well defined, hard and noisy that lift completely off the ports.
3. An orifice that is out of line with the burner venturi.
3. An orifice that is out of line with the burner venturi.