GE zisb480dr 用户手册

To insert framed or overlay panel into the grille:
• Raise the grille panel to stop position.

• Loosen screws on side trim behind frame. Remove

bottom trim. 

Metal panel may be 

slippery. Grip metal panel firmly, so the panel does
not slip out of the frame and cause personal injury
or damage to the frame.

Le panneau en métal

peut bêtre glissant. Tenir fermement le panneau en
métal, de manière à ce que le panneau ne glisse pas
en dehors du cadre en provoquant des blessures
corporelles ou des dommages au cadre.

• Slide panel over the metal backer panel and into

the trim.

• If necessary, tap with a wood block until panel slips

under the top trim piece.

• Reassemble bottom trim. Tighten screws.
• Adjust the hinge spring to accommodate the panel

weight, if necessary.

Raise
Grille
Panel

Adjust Nut Below

Spring to Accommodate

Panel Weight

Loosen

Side

Trim

Screw

Loosen

Side

Trim

Screw

This refrigerator has a 2-position door stop.

When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.

• Open the door to view the bottom hinge. Note the

door stop pin locations. The pin is factory installed
in the 130° position. 

• Close the door. From below, use pliers to unscrew

the door stop and reinstall into the 90° position. 

90˚

130˚

Hinge

Interior

Door

Whenever possible, perform this step for anti-tip 
security, or when anti-tip brackets cannot be used. 
The refrigerator must be secured to prevent tipping

.

• Raise the grille panel to access case trim. 
• Drill hole in trim and drive screw through the trim

into adjacent cabinet.

• Follow the same procedure on the opposite side.

Drive Screws

Through Case Trim Into

Adjacent Cabinets

Raise Grille Panel

to Stop Position