GE zisb480dr 用户手册

Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws

from the door handle.

• Remove handle. Retain all screws.
• Remove 6 screws holding trim, lift off trim. Retain

screws.

• Slide framed panel into the door trim.

Dispenser Models Only:
• The dispenser controls protrude beyond the face of

the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.

• Remove the screws holding the top trim in place.
• Place the freezer panel into the bottom channel and

slide into the hinge side trim.

• Reinstall the top trim piece with screws.

• There are two sets of holes in the handle side trim.

Replace handle side trim by installing the original
screws in the FRONT screw holes. 

• Secure the handle to the door using the REAR screw

holes.

• Follow the same procedures to install the opposite

panel.

• Check to be sure handles are evenly aligned with each

other at the top. To adjust, loosen handle screws and
slide up or down. Tighten screws.

NOTE: Aluminum cover trim is supplied for use with
custom handles on overlay panels. It is not intended for
use with 1/4" panels. Discard the cover trim when using
1/4" framed panels.

Supplied
Handle Shown
in 1/4" Panel
Position

Use Rear Holes

to Secure Handle

  Use Front Holes

to Secure Trim

Refrigerator

Door

Door Trim

Handle 
Trim