Hitachi BZ-1 用户指南

45

SETUP menu

SETUP menu

From the SETUP menu, items shown in the table 
below can be performed.
Select an item using the ▲/▼ cursor buttons, and 
press the ► cursor button or ENTER button to 
execute the item. Then perform it according to the 
following table.

Using the ◄/► cursor buttons adjusts the magnification ratio.

Small 

 Large

• The on-screen menu might be displayed outside of the image 
display area depending on the adjustment value of the ASPECT, 
D-ZOOM, 

 KEYSTONE and 

 KEYSTONE. Changing the values 

of ASPECT, D-ZOOM, 

 KEYSTONE and 

 KEYSTONE  may fix 

the symptom.

Using the ◄/►/▲/▼ cursor buttons adjusts the picture position.
• The D-SHIFT adjustment values are not valid when the D-ZOOM 
is set to 320 (full screen).

Using the ▲/▼ cursor buttons selects the horizontal picture 
position.

LEFT 

 MID  RIGHT

The PICTURE POSITION is not changed if any of the following 
cases apply.
• The ASPECT is set to 16:9 or 16:10.
• The input signal has an aspect ratio of 16:9, 16:10 or verticallly 
smaller than 16:10, while ASPECT is set to NORMAL.
• Horizontal size of the displayed image is full on the effective 
display area, while the ASPECT is set to NATIVE.
• One of the following messages is displayed on the screen:
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"INVALID SCAN FREQ."
• The BLANK or TEMPLATE function is selected.

Using the ◄/► buttons corrects the vertical keystone distortion.

Shrink the bottom of the image 

 Shrink the top of the image

• The adjustable range of this function will vary among inputs. For 
some input, this function may not work well.
• This function will be unavailable when the Transition Detector is on 
(

77) or the PERFECT FIT (46) is adjusted.

(continued on next page)