LXE hx3 参考指南
142
Main Tab
HX3 Reference Guide
E-EQ-HX3RG-C
Main Tab
Access:
| Settings | Control Panel | Scanner | Main tab
Factory Default Settings
Main
Port 1
Port 1
Disabled until auto-detect
Port 2
Ring
Port 3
Disabled until auto-detect
Send key messages (WEDGE)
Enabled
Enable Scanner Sound
Enabled
Imager LED Illumination
Internal
Figure 4-2 Scanner Control / Main
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
Parameter Function
Port
The ports are disabled until the HX3 auto-detects a device tethered to
the port. Port 1 defaults to Bluetooth and Port 2 defaults to Ring when a
Bluetooth enabled HX3 with ring scanner/imager is powered On.
the port. Port 1 defaults to Bluetooth and Port 2 defaults to Ring when a
Bluetooth enabled HX3 with ring scanner/imager is powered On.
Send Key Messages
(WEDGE)
(WEDGE)
When Send Key Messages (WEDGE) is checked any data scan is
converted to keystrokes and sent to the active window. When this
checkbox is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this
latter method is significantly faster than using Wedge.
converted to keystrokes and sent to the active window. When this
checkbox is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this
latter method is significantly faster than using Wedge.