LXE hx3 参考指南
COM1 Tab
143
E-EQ-HX3RG-C
HX3 Reference Guide
Parameter Function
Enable Scanner
Sound
Sound
The default is Enabled. Functionality of the tethered scanner driver
engine includes audible tones on good scan (at the maximum db
supported by the speaker) and failed scan.
engine includes audible tones on good scan (at the maximum db
supported by the speaker) and failed scan.
Disable this parameter when good scan/bad scan sounds are to be
handled by alternate means e.g. application-controlled sound files.
handled by alternate means e.g. application-controlled sound files.
Rejected barcodes generate a bad scan beep. In some cases, the receipt
of data from the scanner triggers a good scan beep from a tethered
scanner, and then the rejection of scanned barcode data by the
processing causes a bad scan beep from the HX3 on the same data.
of data from the scanner triggers a good scan beep from a tethered
scanner, and then the rejection of scanned barcode data by the
processing causes a bad scan beep from the HX3 on the same data.
Imager LED
Illumination
Illumination
The default setting is Internal illumination. The imager has a bank of
three LEDs above the imager aperture that illuminate when External or
Both radio buttons are enabled. The illumination turns off when the
scan is complete.
three LEDs above the imager aperture that illuminate when External or
Both radio buttons are enabled. The illumination turns off when the
scan is complete.
COM1 Tab
Access:
| Settings | Control Panel | Scanner | COM1 tab
Factory Default Settings
COM1 Port (cradle serial port)
Baud Rate
Baud Rate
9600
Stop Bits
1
Parity None
Data Bits
Data Bits
8
Figure 4-3 Scanner Control / COM1
If these values are changed, the default values are restored after a cold boot or reflashing.