LXE hx3 参考指南
182
Summit Client Configuration
HX3 Reference Guide
E-EQ-HX3RG-C
WEP Keys
Please see your System Administrator for complete information about your network WEP key
requirements.
requirements.
To connect using WEP, use the following minimum required profile options..
• Auth Type = Open
• EAP Type = None
• Encryption = Manual WEP
• EAP Type = None
• Encryption = Manual WEP
Figure 5-11 Configure a Summit Profile with WEP
Tap the WEP keys/PSK Keys button. The WEP Key Entry text entry box appears.
Figure 5-12 Summit WEP Keys
Enter the WEP key. If there are more than one set of keys, tap the radio button in front of the Key
to be used.
to be used.
WEP keys may be entered in Hex or ASCII format. For previous versions of the SCU, if the
WEP key entry does not offer a choice between Hex and ASCII, the key must be in Hex (refer to
the Hex Key Format segment that follows).
WEP key entry does not offer a choice between Hex and ASCII, the key must be in Hex (refer to
the Hex Key Format segment that follows).
Once configured, tap OK then tap the Commit button. Ensure the correct Active Config is
selected on the Main tab and warm boot. The SCU Main tab shows the device is associated after
the radio connects to the network.
selected on the Main tab and warm boot. The SCU Main tab shows the device is associated after
the radio connects to the network.