LXE hx3 参考指南
Summit Client Configuration
183
E-EQ-HX3RG-C
HX3 Reference Guide
Hex Key Format
Valid keys are 10 (for 40 bit encryption) or 26 (for 128 bit encryption) hexadecimal characters (0-
9, A-F). Enter the key(s) and tap OK.
9, A-F). Enter the key(s) and tap OK.
ASCII Key Format
Valid keys are 5 (for 40 bit encryption) or 13 (for 128 bit encryption) alphanumeric characters.
Enter the key(s) and tap OK.
Enter the key(s) and tap OK.
LEAP w/o WPA Authentication
If the Cisco/CCX certified Access Point (AP) is configured for open authentication, set the Auth
Type client parameter to Open.
Type client parameter to Open.
If the AP is configured for network EAP only, set the Auth Type client parameter to LEAP.
Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Admin Login password and tap OK.
Tap the Config or Profile tab.
Tap the Config or Profile tab.
Figure 5-13 Configure a Summit Profile for LEAP w/o WPA
Enter the SSID of the Access Point assigned to this profile.
Set Auth Type to Open.
Set EAP Type to LEAP.
Set Encryption to Auto WEP.
Tap the Credentials button.