Ricoh 480W 参考指南

 JOB 

EDITOR 

button above the entry list. 

The settings are on the two cards "Specific" and "Additional". 
They are essentially identical with the cards described above for 

the "Default" section. If you want to make entries in the "Specific" 
tab, read the information given for the "Default Specifics " tab 

ad the 

p pens from Page 126 and the HPGL pens from 

Page 118. 

ummary of all the currently loaded settings. Proceed 

a

1. 

e entries you want to look at in the job 

2. 

drawing in the entry list to the left of the 

3. 

the white "i" for information display in the "View" 

toolbar: 

from Page 100. 

If you want to alter the settings on the "Additional" tab, re
details for the "Default Additionals" given on Page 103 ff. 
As already mentioned, the settings for the sections "Default" and 
"Entry" are essentially identical. But the "Entry" section does not 
offer all pen settings. You can open a tab for the pen settings on 
the "Additional" tab. To do this, click on the "Pen settings" button. 

The button is only active if the entry is an HPGL or Calcomp file. 
When an entry or drawing is marked, the program 
automatically recognizes the format and opens either the 
Calcomp or the HPGL settings automatically when the button is 
clicked. Please read the separate Sections on the pen settings 

for Calcom

Before you can begin with a possible change to the settings, you 
can view a s

s follows: 

Mark the job whos
list above the job. 

Mark the required 
required drawing. 
Click on 

 

For most file formats you can only see the "Drawing" tab. The 
"Drawing" card contains information about the drawing format, 

 

RW-480 PLOTBASE    105