Ricoh 480W 参考指南

 PRINT 

JOB 

This command is used if the plotter has failed to initialize. This 
can happen e.g. if you have already started RW-480 PLOTBASE, 
but forgot to switch on the plotter. In such a case let RW-480 

PLOTBASE run, switch on the plotter and once the plotter has 
warmed up go to the "Plotter" menu and select "Reload Plotter". 
This reloads the plotter driver. Renewed plotter loading can also 
be necessary in cases, in which the plotter has had to be 

switched off due to a malfunction. 

As soon as the status "Problem" is shown in the job list, you can 
read a error message in the status window or by making a 
double click on the job entry. In this chapter reasons for errors 
and solutions to solve problems are appointed. 

In the status windows also errors are appointed, which arise 
because of a wrong handling or malfunction of the plotter. To 
remedy the malfunction of the plotter, please use the Copy 
Reference Manual.  

If you can’t remedy an error, although you have taken the 
suggested solution into account, ask your administrator.  

•  Kernel out of memory 

The main memory is too small. Shut down all programs, 
which are opened additionally and which are not used at the 
moment. If the error message appears furthermore, it is 

useful, to increase main memory of your PC. 

•  Driver is too old 

You installed an older driver version for the Controller 
Board. Install the current version. 

•  Kernel timeout 

Communication between the program and the plotter is 
disturbed. This error can have many reasons: machine has 

been switched off in the meantime, while printing a error  
appears and so on. Remove the error, which caused the 
problem. Thereafter you can start the printing again. After 
this, you can start the printing process again. 

 

RW-480 PLOTBASE    138