Ricoh 480W 网络指南

Monitoring and Configuring the Machine

Note

❒ The access range restricts comput-

ers from use of the machine by IP
address. If you do not need to re-
strict printing, make the setting
"0.0.0.0".

❒ Valid ranges must be from lower

(start address) to higher (end ad-
dress).

❒ Up to five access ranges can be

specified. The entry is invalid if the
target number is omitted.

❒ You cannot access Web Image Mon-

itor from a restricted IP address.

autonet

Use the “autonet” command to con-
figure AutoNet parameters.

❖

❖ View settings

The following command displays
the current AutoNet settings:

msh> autonet

❖

❖ Configuration

You can configure AutoNet set-
tings.

msh> autonet {on|off}

• {on} means "active" and {off}

means "inactive".

❖

❖ Current interface priority configura-

tion display

msh> autonet priority

❖

❖ Interface priority configuration

m s h > a u t o n e t p r i o r i t y
“interface_name”

• You can give interface's Au-

toNet parameter priority.

• Priority settings are available

when multiple interfaces are in-
stalled.

• ip1394 can be specified only

when the IEEE 1394 interface is
installed.

• wlan can be specified only when

the IEEE 802.11b interface is in-
stalled.

Note

❒ If an interface is not selected, the

current interface connection set-
tings remain in effect.

Reference

For details about AutoNet, refer to
autonet parameters.

devicename

Use the "devicename" command to
display and change the machine
name.

❖

❖ View settings

msh> devicename

❖

❖ Machine name configuration

m s h > d e v i c e n a m e n a m e
“string”

• Enter a machine name using up

to 31 alphanumeric characters.

• Set single names for each ma-

chine.

❖

❖ Machine name initialization

msh> devicename clear name

• Reset the machine name to its

default.

Interface name

Interface configured

ether

Ethernet interface

ip1394

IEEE 1394 interface

wlan

IEEE 802.11b interface