Ricoh AP400 安装指南
Network Interface Board Type 2610
27
2
Network Interface Board Type 2610
Note
❒ Depending on the model you use,
the Network Interface Board , the
1394 Interface Unit, the 802.11b In-
terface Unit, and the Bluetooth In-
terface Unit cannot be installed to
the printer at the same time. For
more information, see p.17 “In-
stalling Options”.
1394 Interface Unit, the 802.11b In-
terface Unit, and the Bluetooth In-
terface Unit cannot be installed to
the printer at the same time. For
more information, see p.17 “In-
stalling Options”.
Important
❒ Before touching the Network In-
terface Board, touch something
metal to discharge any static elec-
tricity. Static electricity can dam-
age the Network Interface Board.
metal to discharge any static elec-
tricity. Static electricity can dam-
age the Network Interface Board.
❒ Do not subject the Network inter-
face board to physical shocks.
❒ Use the shielded twisted-pair
(STP) network interface cable.
Installing the Network
Interface Board
Interface Board
AAAA
Check the contents of the box for
the following items:
• Network Interface Board
• Ferrite Core
• Installation Guide
the following items:
• Network Interface Board
• Ferrite Core
• Installation Guide
BBBB
Confirm that the followings are
true:
• The power switch is turned off.
• The interface cable is un-
true:
• The power switch is turned off.
• The interface cable is un-
plugged from the printer.
Note
❒ The interface cable is not includ-
ed in the box. Make sure that the
interface cable you use is appro-
priate for your computer.
interface cable you use is appro-
priate for your computer.
CCCC
Remove the two screws holding
the controller board in place.
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ These screws are used again in
step
DDDD
Pull out the handle of the control-
ler board.
ler board.
ZKEX750E
ZKEX370E