Ricoh AP400 安装指南
Installing Options
28
2
EEEE
Holding the handle, slowly pull
out the controller board.
out the controller board.
FFFF
Place the controller board on a flat
surface.
surface.
GGGG
Remove the two screws and the
cover of the Network Interface
Unit mounting bracket.
cover of the Network Interface
Unit mounting bracket.
Note
❒ These screws are used again in
step
.
❒ The removed cover is not used
when installing the Network In-
terface Board.
terface Board.
HHHH
Insert the end of the Network In-
terface Board into the opening
(
terface Board into the opening
(
A
A
A
A), and then push down until it
clicks (
B
B
B
B).
IIII
Fasten the Network Interface
Board to the controller board.
Board to the controller board.
ZKEX720E
ZKEX041E
ZKEX422E
ZKEX432E
ZKEX444E