Haier HWS60-40 用户手册
1
OFF
SPIN TIMER
2
3
4
5
WATER INLET
Usage of the panel
Set the spinning duration
depending on the category
and amount of the articles.
depending on the category
and amount of the articles.
4.If extra drain hose is needed , please make separate
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed
1.5m.
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed
1.5m.
<10cm
> 30mm
<1.5m
To set to below 1 minute, first
set to 2 minute then turn it
back. it can increase the
service life of the timer
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than
10cm , or the drainage will not be smooth enough
and cause incomplete drainage.
10cm , or the drainage will not be smooth enough
and cause incomplete drainage.
2. Do not tramp or press the drain hose.
3. If the drain hose is too long, cut it at mid point.To make
smooth drainage, cut the front end of the hose slantingly.
smooth drainage, cut the front end of the hose slantingly.
Water-added rinsing-
spinning,to be used
during defoaming
-spinning.
spinning,to be used
during defoaming
-spinning.
The musts in using
Please make the machine stand horizontally.
Confirm that the washing machine is earthed reliably . Then insert the power plug
Confirm that the washing machine is earthed reliably . Then insert the power plug
Into the receptacle. Do not connect the earth terminal to the gas pipe and tap
water pipe.
water pipe.
Put down the drain hose .
Preparation before spinning
Using sequence
2
OFF
SPIN TIMER
4
6
8
10
Set the spinning duration
depending on the category
and amount of the articles.
depending on the category
and amount of the articles.
To set to below 2 minute, first
set to 4 minute then turn it
back. it can increase the
service life of the timer
HWS60-40
HWS60-50