Haier HWS60-40 用户手册

1

Put the laundries in properly

2

Put the gland in properly

3

Close the inner and outer cover of the spin tub 

4

Do you need  water-added

Rinsing-spinnning

 

Water-added rinsing-spinning

has an effect that can remove the surplus liquid dirt,

  

Spin for about

1~2 minutes

Foam-removing

spinning

Remove most of 

the  foam  extra

detergent liquid. 

Remove the detergent

liquid remained

The effect  is best when the laundries  quantity is below  80% of the rated value.

Spin

Fill  water  for 

about 1 minutes

Spin for about

1~2 minutes

Note: 

Refer to the Notes on Spinning carefully.

5 Take the laundry out when the spinning ends. 

When the spinning ends, open the top lid and the interior lid. Then take out
 the depression cover and laundry after the  spinning drum has stopped 
rotation completely. 

Note: If there needs no 

water-added rinsing-spinning

, set the duration for

           spinning directly.

Water  inlet entrance 

Water inlet hose

The water hose should be connected
 as shown in the right figure.

It works in a way as follows: 

If you  need 

 water-added rinsing-spinning

, please check the connection

 between the water hose and filling inlet.

Notes on Spinning

Use  the foam-removing spin-

ning  to remove the extra deter-

gent liquid. It can both shorten

 the washing  time and save the

 water consumption.

Please put in the gland properly even if the laundries 

.Do not leave any articles above the depression cover.

Push

Gland

Push

Proper The laundries

are slanting

Proper

No gland

quantity is small.