Frigidaire plcs389ccc 安装指导

4

This appliance is manufactured with the neutral terminal
connected to the frame.

(The 3-conductor cord or cable must be replaced with a
4-conductor cord or cable where grounding through the
neutral conductor is prohibited in new installations,
mobile homes, recreational vehicles or in other areas
where local codes do not permit neutral grounding)
If local codes permit connection of the frame grounding
conductor to the neutral wire of the copper power supply
cord (see Figure 4).

1. Remove the 3 screws at the lower end of the rear

wire cover, then bend the lower end of the rear wire
cover (access cover) upward to expose range
terminal connection block (see Figure 3).

BEND REAR WIRE COVER HERE

FOR ACCESS TO ELECTRIC HOOK-UP

2. Remove the 3 loose nuts (after you removed the

rubber band) on the terminal block using a 3/8" nut
driver or socket.

3. Connect the neutral white wire of the copper power

supply cord to the center silver-colored terminal of
the terminal block, and connect the other wires to
the outer terminals.  Match wires and terminals by
color (red wires connected to the right terminal,
black wires connected to the left terminal).

4. Replace the 3 nuts on the terminal block (see Figure

4).

5. Lower the terminal cover and replace the 3 screws.

Silver Colored Terminal

1 1/8" (2.9 cm) Dia.
Direct Connection
Hole. Punch Out
Knockout for 1 3/8"
(3.5 cm) Dia. Cord
Kit Hole.

To 240 V
Receptacle

A User Supplied Strain-
relief Must Be Installed
at This Location.

Black
Wire

Terminal
Block

Neutral

(White Wire)

Grounding
Strap

Red
Wire