Frigidaire plcs389ccc 安装指导

5

Terminal Block

Silver Colored Terminal

Red
Wire

Neutral
(White Wire)

Ground (Bare
Copper Wire)

To 240 V Receptacle

A User Supplied
Strain-relief Must
Be Installed at
This Location

Black Wire

1 1/8" (2.9 cm)
Dia. Direct
Connection
Hole. Punch
Out Knockout
for 1 3/8 (3.5
cm) Dia. Cord Kit
Hole.

NOTE: Be sure to remove the
supplied grounding strap.

1. Remove the 3 screws at the lower end of the rear

wire cover, then raise the lower end of the rear wire
cover (access cover) upward to expose range
terminal connection block (see Figure 3).

2. Remove the 3 loose nuts (after you remove the

rubber band) on the terminal block using a 3/8" nut
driver or socket.

3. Remove the grounding strap from the terminal block

and from the appliance frame.

4. Connect the ground wire (green) of the copper

power supply cord to the frame of the appliance
with the ground screw, using the hole in the frame
where the ground strap was removed (see Figure 5).

5. Connect the neutral of the copper power supply cord

to the center silver-colored terminal of the terminal
block, and connect the other wires to the outer
terminals.  Match wires and terminals by color (red
wires connected to the right terminal, black wires
connected to the left terminal).

6. Replace the 3 nuts on the terminal block (see Figure

5).

7. Lower the terminal cover and replace the 3 screws.

If the appliance is connected directly to the circuit
breaker, fuse box or junction box, use flexible, armored
or nonmetallic sheathed copper cable (with grounding
wire).  Supply a U.L. listed strain-relief at each end of
the cable.  At the appliance end, the cable goes through
the Direct Connection Hole (see Figure 5) on the Cord
Mounting Plate.  Wire sizes (copper wire only) and
connections must conform to the rating of the appliance.

Where local codes permit connecting the appliance-
grounding conductor to the neutral (white) wire
(see Figure 6): (The 3-conductor cord or cable must be
replaced with a 4-conductor cord or cable where
grounding through the neutral conductor is prohibited in
new installations, mobile homes, recreational vehicles or
in other areas where local codes do not permit neutral
grounding)
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box:

a) Connect the green (or bare copper) wire, the

white appliance cable wire, and the neutral
(white) wire together.

b) Connect the 2 black wires together.
c) Connect the 2 red wires together.

Cable from Residence

Junction

Box

White Wire

U.L.-listed Conduit
Connector (or CSA
listed)

Cable from

Appliance

Green
(or Bare Copper)
 Wire

Red
Wires

Neutral

(white) Wire

Black
Wires