Nortel 4000 安装指南
Nautica Memory Module
300275-D Rev. 00
6-3
Due to the size constraints of the Nautica 4000, position
J9 runs underneath the ISDN+or QuadWAN module
installed onto the expansion slot at positions J10 to J13. If
you have an ISDN+ module installed, remove it and any
attached BRI-U/BRI-STs and modem modules that may
be attached to it.
J9 runs underneath the ISDN+or QuadWAN module
installed onto the expansion slot at positions J10 to J13. If
you have an ISDN+ module installed, remove it and any
attached BRI-U/BRI-STs and modem modules that may
be attached to it.
For information on the ISDN+ module, refer to
Chapter 4. For more information on the BRI-U and
BRI-ST modules, refer to Chapter 2. Chapter 3 provides
information on the Nautica modem module.
Chapter 4. For more information on the BRI-U and
BRI-ST modules, refer to Chapter 2. Chapter 3 provides
information on the Nautica modem module.
3.
Position J9 (
) allows for two Memory modules
to be installed at any one time. Use the combination of
modules you require to achieve optimum memory.
modules you require to achieve optimum memory.
4.
, the Memory modules are inserted
at an angle to the base of the Nautica 4000.
Figure 6-2.
Positioning the Nautica Memory Module
The 72 pins at the bottom of the Memory module are
inserted into the slots at position J9. The chips should
face towards the rear of the unit as shown in
inserted into the slots at position J9. The chips should
face towards the rear of the unit as shown in
.
5.
Close the Nautica 4000 (see Chapter 1).
6.
Turn on the unit. The new memory is automatically
detected and initialised as part of the normal start up
procedure for the Nautica 4000.
detected and initialised as part of the normal start up
procedure for the Nautica 4000.