Nortel 4134 快速安装指南
36
Installing the Secure Router 4134 chassis and hardware components
8
Use a Phillips screwdriver to tighten the two captive screws to secure
the module to the chassis.
the module to the chassis.
—End—
Installing or removing an internal VPN/IPSec module
Use the instructions in this section to install, remove, or replace the internal
VPN/IPSec module. This internal module is not hot-swappable.
VPN/IPSec module. This internal module is not hot-swappable.
If you ordered the VPN/IPSec module with your Secure Router 4134, the
Secure Router ships with the VPN/IPSec module installed.
Secure Router ships with the VPN/IPSec module installed.
Average time to install the internal VPN/IPSec module: 2 minutes.
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
the unit is powered.
CAUTION
Vorsicht
Öffnen Sie nicht die Secure Router 4134 Service-Abdeckplatte,
wenn es Energie an der Maßeinheit gibt.
wenn es Energie an der Maßeinheit gibt.
Installing the internal VPN/IPSec module
Use the procedure in this section to install an internal VPN/IPSec module. If
you are replacing a VPN/IPSec module, also see
you are replacing a VPN/IPSec module, also see
.
Prerequisites
•
Ensure you have a VPN/IPSec module ready to install before opening
the service access panel.
the service access panel.
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure the Secure Router 4134 has the power switched off.
Nortel Secure Router 4134
Quick Start
NN47263-100
01.01
Standard
10.0
16 July 2007
Copyright © 2007, Nortel Networks
.