Nortel 4134 快速安装指南
Installing or removing an internal VPN/IPSec module
37
Procedure steps
Step
Action
1
Remove the two screws at the rear of the Secure Router 4134 that
hold the service access panel secure. Remove these two screws
only. See the following figure.
hold the service access panel secure. Remove these two screws
only. See the following figure.
2
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Secure Router 4134.
3
Locate the internal VPN/IPSec module connector slot.
4
Holding the VPN/IPSec module by its edges, align the connector
with the slot on the Main Board, pushing down gently, but firmly,
to seat the module.
The following figure shows the location for installing the VPN/IPSec
module.
with the slot on the Main Board, pushing down gently, but firmly,
to seat the module.
The following figure shows the location for installing the VPN/IPSec
module.
Nortel Secure Router 4134
Quick Start
NN47263-100
01.01
Standard
10.0
16 July 2007
Copyright © 2007, Nortel Networks
.