Nortel 4134 快速安装指南
50
Configuring the Secure Router 4134 for remote access
•
Ensure you have the supplied female DB-9 to RJ-45 adapter if you
require it for connection to your terminal or PC.
require it for connection to your terminal or PC.
•
Ensure you have the Secure Router 4134 securely installed in the
equipment rack.
equipment rack.
•
Ensure you have powered up the terminal or PC.
Procedure steps
Step
Action
1
Set the terminal protocol as follows:
a. 9600 baud
b. 8 data bits
c. 1 stop bit
d. no parity
e. flow control: None
2
Insert the male RJ-45 connector in the console port on the rear
panel of the Secure Router 4134.
panel of the Secure Router 4134.
3
Connect the female DB-9 to RJ-45 adapter to the opposite end of
the console cable, if necessary.
the console cable, if necessary.
4
Insert the RJ-45 or female DB-9 connector (dependent on your
equipment) in a terminal or PC.
equipment) in a terminal or PC.
5
Power up the Secure Router 4134.
—End—
Establishing remote access
The first time you log on to the Secure Router 4134 CLI, you perform initial
configuration such as the following:
configuration such as the following:
1. Configure the IP address for the management port.
2. Configure the next hop (gateway IP address).
3. Verify a successful connection.
4. Enable remote access.
You can enable SSH or Telnet for remote connections.
Nortel Secure Router 4134
Quick Start
NN47263-100
01.01
Standard
10.0
16 July 2007
Copyright © 2007, Nortel Networks
.