Nortel 2350 参考指南
152 Planning the Nortel WLAN 2300 System
NN47250-102 (320666-G Version 02.01)
•
To list access on other floors that can be detected from this RF measurement point, select Show
APs on Other Floors.
APs on Other Floors.
See
for information about the fields in the display.
7
Click OK to save the changes and close the box.
8
Do one of the following:
•
To use the RF interactive measurement mode, see
.
•
To generate network design information, see
.
•
Click Finish to save the changes and close the wizard.
Using RF Interactive Measurement Mode
RF interactive measurement mode is useful when you are troubleshooting or surveying the coverage areas on the floor.
You can quickly measure signal strengths for any location on the floor.
You can quickly measure signal strengths for any location on the floor.
To use the RF interactive measurement mode
1
Click the
icon in the toolbar.
2
Click any location on the floor. Received signal strength indication (RSSI) measurements for the selected
location appear next to the Floor View. See
location appear next to the Floor View. See
for
information about the fields in the display.
Reading the RF Measurement Table
The projected signal strengths for the planned equipment from that measurement point are shown in the RF measure-
ment table.
ment table.
X-Y coordinates for the measurement point and display options are also available to customize the RSSI table. Using
this interactive mode can be valuable when verifying deployment coverage with a portable WLAN measurement tool on
the floor.
this interactive mode can be valuable when verifying deployment coverage with a portable WLAN measurement tool on
the floor.