Nortel 2350 参考指南
Configuring Wireless Parameters 255
Nortel WLAN—Management Software 2300 Series Reference Guide
lists how many APs you can configure on a WSS, and how many APs a switch can boot. The numbers are for
directly connected and Distributed APs combined.
To configure a directly connected AP
1
Access the Create Direct-Connect AP wizard:
a
a
Select the Configuration tool bar option.
b
In the Organizer panel, click the plus sign next to the WSS.
c
Click the plus sign next to Wireless.
d
Select Access Points.
e
In the Task List panel, select AP.
2
Select the WSS port the AP will be connected to from the Available Connection drop-down list.
3
Click Next.
4
Select the AP model from the AP Model list.
Table 4: Maximum APs Supported Per Switch
WSS Model
Maximum Configured
Maximum Booted
2382
320
32, 64, 96 or 128, depending on
the license.
the license.
2380
300
40, 80, or 120, depending on
the license.
the license.
2360/2361
30
12
2350
8
3
Note. For an AP that is indirectly connected to the WSS through an intermediate Layer 2 or
Layer 3 network, configure a Distributed AP instead. (See
Layer 3 network, configure a Distributed AP instead. (See
.)
Note. You cannot configure any gigabit Ethernet port, or port 7 or 8 on a 2360/2361 switch,
or port 1 on a 2350 switch, or port 3 on a 2382 switch, as an AP port. To manage an AP on
either a 2380 or 2382 switch, configure a Distributed AP connection on the switch.(See
or port 1 on a 2350 switch, or port 3 on a 2382 switch, as an AP port. To manage an AP on
either a 2380 or 2382 switch, configure a Distributed AP connection on the switch.(See
Note. Configuring a directly connected AP in a port converts the port to an AP
access port. If the port is a statically configured member of a VLAN, the port is
removed from the VLAN.
access port. If the port is a statically configured member of a VLAN, the port is
removed from the VLAN.