Nortel 2350 参考指南
444 Optimizing a Network Plan
NN47250-102 (320666-G Version 02.01)
4
You can choose to import measurements from the network, a site survey file, or both:
a
a
If you want to use RF neighborhood information imported from an AP in the network,
click Yes next to Network.
click Yes next to Network.
a
If you want to import measurements from a site survey file, click Yes next to File, and in
the File Format listbox, select Ekahau. Then click Choose to navigate to the csv file that
contains the RF measurement data.
the File Format listbox, select Ekahau. Then click Choose to navigate to the csv file that
contains the RF measurement data.
5
In the Map Name field, specify the map name.
6
Click Next.
The import progress is displayed. When the import is done, check the Total valid RF
measurements found line in the progress messages.
measurements found line in the progress messages.
•
If the number is greater than 0, WLAN Management Software successfully imported
measurements.
measurements.
•
If the number is 0, no measurements were imported. Try the import again and verify
that the map name is correct.
that the map name is correct.
Applying the RF Measurements to the Floor Plan
1
Under Site Survey in the Task List panel, click Optimize.
A wizard appears, listing the progress of the request.
•
The Total number of RF measurements that did not intersect any object line lists the
number of measurements that did not experience attenuation due to an RF obstacle
in the path between them.
number of measurements that did not experience attenuation due to an RF obstacle
in the path between them.
Note.
The map name must match the name specified in the site survey work
order, and must be the same map name used in the site survey tool.