Nortel 2350 用户指南

Appendix A:Troubleshooting a WSS 671

Nortel WLAN—Security Switch 2300 Series Configuration Guide

You can recover any model switch if you have lost or forgotten the enable password. You also can recover a 2350 even 
if you have lost or forgotten the login password.  

To recover a WSS, use one of the following procedures.

After the switch has fully booted, use a pin to press the factory reset switch for at least 5 seconds. This 
operation erases the switch’s configuration.

Use a web browser to access IP address 192.168.100.1. This address accesses the Web Quick Start.

Use the Web Quick Start to set the administrator usernames and passwords and other parameters. Make 
sure you reconfigure the switch’s IP connection.

See 

.

Reboot the switch, and interrupt the WSS boot process. 

Insert a pin into the restart switch or power the WSS off and on again to cause the WSS to reboot. 

 shows the location of the restart switch. The restart switch on a 2360/2361, 2380 or 2382 switch 

is also located next to its serial console port.

Configuration information 
disappears after a software 
reload.

The configuration changes 
were not saved.

1. Retype the commands for the missing 

configuration information.

2. Type the save config command to save the 

changes.

Mgmt LED is quickly 
blinking amber.
CLI stops at boot prompt 
(boot>).

The WSS was unable to load 
the system image file.

Type the boot command at the boot prompt.

Recovering the system will delete your configuration file.