Nortel 2350 用户指南
672 Appendix A:Troubleshooting a WSS
NN47250-500 (320657-F Version 02.01)
Figure 1.
WSS restart switch location
2
When you see descending numbers on the console, press q, then press Enter.
3
Type the following command at the boot> prompt:
boot>
boot OPT+=default
If you do not type the command before the reset cycle is complete, the WSS returns to the state it was in before you
restarted it.
restarted it.
Once you have entered the command, the WSS returns to its initial unconfigured state. For information on how to
configure the WSS, see
configure the WSS, see
.
For model 2382, 2360/2361, you also can reconfigure basic parameters using the Web Quick Start. Use a web browser to
access IP address 192.168.100.1.
access IP address 192.168.100.1.
Configuring and managing the system log
System logs provide information about system events that you can use to monitor and troubleshoot WSS Software.
Event messages for the WSS and its attached APs can be stored or sent to the following destinations:
Event messages for the WSS and its attached APs can be stored or sent to the following destinations:
•
Stored in a local buffer on the WSS
•
Displayed on the WSS console port
•
Displayed in an active Telnet session
•
Sent to one or more syslog servers, as specified in RFC 3164
The system log is a file in which the newest record replaces the oldest. These entries are preserved in nonvolatile
memory through system reboots.
memory through system reboots.
Caution!
Use an enable password that you will remember. If you lose the password, the
only way to restore it causes the system to return to its default settings and wipes out the
configuration.
configuration.
1
21
22
Link
AP
AP
Mgmt
Console
Rst
Link
AP
AP
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
100-240V
50/60 Hz
8A MAX
50/60 Hz
8A MAX
DISCONNECT
ALL POWER
BEFORE
SERVICING
ALL POWER
BEFORE
SERVICING
Restart switch
840-9502-0026