Nortel 4000 发行公告

300115-B Rev. A

    Remote Access Software Version 5.3 Release Notes

42

This section describes a new superuser CLI command, afd, and other
changes to AFD not reflected in the Release 5.1 UNIX documentation.

The new superuser afd command allows manual downloading of
firmware for a designated WAN module. The syntax is:

afd device [filename]

 describes the arguments.

Table 6 Arguments for the afd Command

Argument

Description

Specifies the WAN module firmware to be downloaded.
Use ct12 to designate WAN 1, and ct13 to designate
WAN 2. ct12 and ct13 are the channels over which the
firmware is downloaded.

Specifies the name of the load host file containing the
firmware to be downloaded. If this argument is omitted,
afd checks /usr/spool/erpcd/bfs/afd_list to determine the
file to be downloaded.

If you specify filename, the firmware in that file is
downloaded once. When you reboot, the firmware file
downloaded reverts to one of those listed in afd_list –
unless download wan never or download wan check is
specified in the configuration file. If download wan
check is configured, AFD performs all the requisite
testing for a download, but does not actually carry out the
download. Test results are syslogged; you can then issue
or not issue the afd command based on those results.

Additional information on AFD and afd_list follows this
table and is also contained in the manual Managing
Remote Access Concentrators Using Command Line
Interfaces.