Nortel 5399 快速安装指南
118352-A Rev. A
Quick-Start Guide for Remote Access Concentrators
6
Set the Network Address
This section uses the IP addresses established in Task 2. To set the network
addresses:
addresses:
1.
At the ROM monitor prompt, enter addr and respond to the
prompts as shown in the example. To accept the default shown
in brackets, press the Return key.
prompts as shown in the example. To accept the default shown
in brackets, press the Return key.
For illustration purposes, this example shows a RAC on an Ethernet
network with the IP address 192.9.200.62. The host system address
is 192.9.200.55. The router gateway address would be 192.9.200.1
for this subnet to access other subnets.
network with the IP address 192.9.200.62. The host system address
is 192.9.200.55. The router gateway address would be 192.9.200.1
for this subnet to access other subnets.
monitor:: addr
Enter Internet address:: 192.9.200.62
Enter Subnet mask [255.255.255.0]::
Enter Broadcast address 192.9.200.55
Enter preferred Load Host address:: 192.9.200.55
Enter Preferred Dump Host [0.0.0.0]::192.9.200.55
Enter Load/Dump Gateway address:: 192.9.200.45
Select type of IP packet encapsulation (ieee802/
ethernet) [<ethernet>]::
Load Broadcast y/n [y]::
2.
After you enter the address path names, enter ad -d to verify the
IP address.
IP address.
3.
After you verify the IP address, set the operating image.