Nortel 5399 快速安装指南
118352-A Rev. A
Quick-Start Guide for Remote Access Concentrators
4
Task 4: Software Image
Determine the software image location (RAC or load host). The software
image is shipped with the RAC and is stored in flash memory. Typically
you would select to load from flash memory, but you can also load from
a TFTP load directory from a load host.
image is shipped with the RAC and is stored in flash memory. Typically
you would select to load from flash memory, but you can also load from
a TFTP load directory from a load host.
Task 5: Install RAC Software
Follow the software install procedures for the operating system you are
using. For detailed installation procedures, refer to Installing Remote
Access Concentrator Software for Windows and Windows NT and
Installing Remote Access Concentrator Software for UNIX.
using. For detailed installation procedures, refer to Installing Remote
Access Concentrator Software for Windows and Windows NT and
Installing Remote Access Concentrator Software for UNIX.
Task 6: Install the RAC
Install the Model 5399 or Model 8000 RAC. The Model 5399 is installed
in a System 5000 MSX chassis and receives signal and power from the
backplane connectors. The model 8000 RAC is a standalone chassis that
requires the following cables:
in a System 5000 MSX chassis and receives signal and power from the
backplane connectors. The model 8000 RAC is a standalone chassis that
requires the following cables:
•
Ethernet
•
Console
•
Synchronous (if used)
•
Power
Configure the RAC before connecting the WAN cables.