Nortel 15000 安装指导
Installing a Power Module in the Versalar Switch Router 15000
2-10
302764-B Rev 00
If either of the two LEDs on the power module do not turn on, contact the Nortel
Networks Technical Solutions Center.
Networks Technical Solutions Center.
Removing an AC Power Module
To remove a power module:
1.
Using a flat-tip screwdriver, loosen the captive screw that fastens the
power module to the AC power unit.
power module to the AC power unit.
2.
Grasp the latch and gently pull it towards you until the power module
disengages (
disengages (
).
3.
Grasp the handle of the power supply with your other hand and using
both hands, pull the power module out of the AC power unit.
both hands, pull the power module out of the AC power unit.
You can remove an operational power module without affecting the operation
of the Versalar 15000. When you remove a power module, the LEDs on the
power module turn off, and the Versalar 15000 automatically redistributes the
load to the remaining power module.
of the Versalar 15000. When you remove a power module, the LEDs on the
power module turn off, and the Versalar 15000 automatically redistributes the
load to the remaining power module.
4.
Install a new power module (see “Installing an AC Power Module” on
page 2-8) or install a power filler plate (described in the next section).
page 2-8) or install a power filler plate (described in the next section).
Warning:
The sides of the power module are hot when you remove it from the
power unit that has been operating recently. Hold the power module by the
bottom.
bottom.