Nortel 15000 参考指南
show ppp line config
308689-B Rev 00
133
The output includes the following information:
show ppp line config
The
show ppp line config
command displays information about the configured
PPP line parameter values for the specified interface. This command allows for
the following options:
the following options:
The output includes the following information:
Name
Circuit for which this command displays information.
State
Operational state of the interface.
Local Config
IP address that this router wants to use.
Local Address
IP address that the peer router wants the local router to
use.
use.
Remote Address
IP address that the remote peer wants to use.
-name
<value>
Displays protocol information for only the named circuit.
-slot
<value>
Displays protocol information for only the specified slot.
Name
Circuit for which this command displays information.
Slot/Conn/Channel
Identifier for the slot, DS3 connector, and DS1.
LCP State
Operational state of the Link Control Protocol (LCP).
Restart Timer
Number of seconds that the restart timer waits before
retransmitting data.
retransmitting data.
Echo Req Freq
Number of seconds that the router waits between the
transmission of echo-request packets.
transmission of echo-request packets.
Echo Rep Loss
Maximum number of unacknowledged echo-reply packets
that the router transmits before declaring the
point-to-point link down.
that the router transmits before declaring the
point-to-point link down.
Max Conf Req
Maximum number of unacknowledged configure-request
packets that the router transmits before assuming that the
peer router on the other end of the link is unable to
respond.
packets that the router transmits before assuming that the
peer router on the other end of the link is unable to
respond.