Nortel 15000 参考指南
show t1 ds1 summary
308689-B Rev 00
157
show t1 ds1 summary
The
show t1 ds1 summary
command displays summary information for all
MCT3 and MCOC3 channels, or for a specific slot. This command allows for the
following options:
following options:
The output includes the following information:
-slot
<value>
Displays summary information for the specified slot only.
<value>
value is any of the
following:
<slot>
<slot/conn>
<slot/conn/chan>
value is any of the
following:
<slot>
<slot/conn>
<slot/conn/chan>
Displays information for the specified
slot/connector/channel.
slot/connector/channel.
T1 over Mct3 summary
Mct3 Channel
Identifier for the slot, DS3 connector, and T1 channel.
Administrative State
Current administrative state.
Operational State
Current operational state.
Alarms
Current alarm state.
Pri/Sec Clock
Configured primary/secondary source of the Tx clock for
the MCT3 channel interface.
the MCT3 channel interface.
Actual Clock
Clock source currently in use by the MCT3 channel
interface.
interface.
MTU
Largest frame size that can be received by the MCT3
channel. Anything larger than the MTU will be discarded.
channel. Anything larger than the MTU will be discarded.
Framing
Framing mode. Possible values here are extended
superframe (ESF) or superframe (SF).
superframe (ESF) or superframe (SF).
Setup Alarm Threshold
Minimum amount of time required before entering (or
exiting) an alarm state due to changes on the DS1.
exiting) an alarm state due to changes on the DS1.
Clear Alarm Threshold
Fdl Address
One of two Facility Data Link (FDL) target address
modes. It determines whether the near-end FDL will
respond to High Level Data Link Control (HDLC) address
AZ or BY in the FDL messages received from the far end.
modes. It determines whether the near-end FDL will
respond to High Level Data Link Control (HDLC) address
AZ or BY in the FDL messages received from the far end.