Nortel 15000 参考指南
show ip disabled
308689-B Rev 00
77
show ip disabled
The
show ip disabled
command displays information about disabled IP
interfaces. The output includes the following information:
show ip enabled
The
show ip enabled
command displays information about enabled IP interfaces.
The output includes the following information:
show ip filter interface
The
show ip filter interface
command displays information about traffic filters
configured on IP interfaces. This command allows for the following options:
Circuit
Name of the circuit associated with the IP interface.
Cct #
Number of the circuit in the router’s active MIB.
State
Status of the IP interface: up or down.
IP Address
IP address of the interface.
Mask
Subnet mask of the IP interface.
Circuit
Name of the circuit associated with the IP interface.
Cct #
Number of the circuit in the router’s active MIB.
State
Status of the IP interface: up or down.
IP Address
IP address of the interface. IP address 0.0.0.0 indicates
that the circuit is associated with an unnumbered
interface.
that the circuit is associated with an unnumbered
interface.
Mask
Subnet mask of the IP interface.
MAC Address
Layer 2 address of the IP interface.
-name
<name>
Displays only those filters on interfaces that match the
specified name.
specified name.
-direction
<name>
Displays only those filters on interfaces that match the
specified direction.
specified direction.
<interface>
Displays only those filters on the specified interface.