Nortel 15000 用户指南
Managing and Troubleshooting the Versalar Switch Router 15000
4-6
302768-C Rev 00
rate
enables continuous polling of the system’s event log to display new event
messages. The
-p
option uses a default rate of 5 seconds. You can change this
value by entering a rate in seconds. The system displays the events that occur
between polling intervals.
between polling intervals.
code_no.
is an event code number or a range of event code numbers. The system
displays the events associated with the specified event code.
-w
enables the
log
command to provide console output in wide format.
Examples
log
Displays all fault, warning, and info events in memory.
log 9:ftp.log
Displays all events saved to the ftp.log file stored on
volume 9.
volume 9.
log -d12/12/98
Shows all events logged since December 12, 1998.
log -t09:02:00
Shows all events logged since 9:02 today. If it is earlier
than 9:02, the console displays all events logged since
9:02 yesterday.
than 9:02, the console displays all events logged since
9:02 yesterday.
log -eTFTP
Displays all events logged by the TFTP service.
log -eGAME -eIP
Displays all events logged by the GAME and IP
services.
services.
log -ffw
Displays all fault and warning events.
log -s10
Shows all events logged in slot 10.
log -eTFTP -ffw -s10
Displays all fault and warning events logged by the
TFTP service in slot 3.
TFTP service in slot 3.
log -eTCP -eTELNET -ffw
Displays all fault and warning events logged by the
TELNET and TCP services.
TELNET and TCP services.
log -p10
Shows all events logged in the past 10 seconds.
log -c8
Shows all events associated with event code 8.
log -w
Displays all events in wide format.