Nortel 15000 用户指南
Monitoring and Troubleshooting
302768-C Rev 00
6-3
Specifying FDL Performance Messages Sent to Another Device
You can specify the source of send performance messages (either subscriber or
carrier) for the Versalar 15000. To do so, go to the T1 or FT1 prompt (for example,
carrier) for the Versalar 15000. To do so, go to the T1 or FT1 prompt (for example,
t1/2/1/4
or
ft1/2/1/5
) and enter the following command:
send-prm-cr-address-bit prm-{ci
|
carrier}
ci
(the default setting) specifies the customer installation (CI) as the source of
PRMs.
carrier
specifies the carrier as the source of PRMs.
The following example shows how to specify the carrier as the source of PRMs
over FT1 channel 5, slot 2, connector 1:
over FT1 channel 5, slot 2, connector 1:
ft1/2/1/5#
send-prm-cr-address-bit prm-carrier
ft1/2/1/5#
Specifying FDL Performance Messages Received from Another Device
You can specify whether a T1 or FT1 channel accepts PRMs from the subscriber
or the carrier. If the software receives a performance message on a channel from a
source other than the one for which it is configured, it discards the PRM.
or the carrier. If the software receives a performance message on a channel from a
source other than the one for which it is configured, it discards the PRM.
Go to the T1 or FT1 prompt (for example,
t1/2/1/4
or
ft1/2/1/5
) and enter the
following command:
accept-prm-cr-address-bit prm-{ci
|
carrier}
ci
(the default setting) accepts PRMs from the subscriber.
carrier
accepts PRMs from the carrier.
The following example shows how to set FT1 channel 5, slot 2, connector 1 to
accept PRMs from the carrier:
accept PRMs from the carrier:
ft1/2/1/5#
accept-prm-cr-address-bit prm-carrier
ft1/2/1/5#