Lowrance lcx-112c 操作指南

 

16

B. Two-piece bracket: Assemble the transducer and bracket as shown 

in the following figure. Temporarily slide the bolt though the transducer 
assembly but don't tighten the nut at this time. Hold the assembled 

transducer and bracket against the transom. Looking at the transducer 
from the side, check to see if it will adjust so that its face is parallel to 

the ground. If it does, then the "A" positions are correct for your hull. 
If the transducer's face isn't parallel with the ground, remove and 
disassemble the transducer and ratchets. Place the ratchets into the 

bracket holes with the letter "B" aligned with the bracket alignment 

mark. Place them on the transducer aligned with the 12 o'clock 
position on the transducer stem. 
Reassemble the transducer and bracket and place them against the 

transom. Again, check to see if you can move the transducer so it's 
parallel with the ground. If you can, then go to step 3B. If it doesn't, 

repeat step 2B, but use a different alignment letter until you can 

place the transducer on the transom correctly. 

 

A. One-piece bracket: Once you determine the correct position for 
the ratchets, assemble the transducer as shown in the following 

figure. Don't tighten the lock nut at this time.