Lowrance lcx-112c 操作指南

 

18

Both bracket types: Attach the transducer to the transom. Slide the 

transducer up or down until it's aligned properly with the bottom of 
the hull as shown in the preceding and following figures. Tighten the 

bracket's mounting screws, sealing them with the caulking compound. 

Adjust the transducer so that it's parallel to the ground and tighten 

the nut until it touches the outer washer, then add 1/4 turn. Don't 

over tighten the lock nut! If you do, the transducer won't "kick-up" if 
it strikes an object in the water. 

  

 

6. Route the transducer cable through or over the transom to the sonar 

unit. Make sure to leave some slack in the cable at the transducer. If 

possible, route the transducer cable away from other wiring on the 
boat. Electrical noise from the engine's wiring, bilge pumps, VHF radio 

wires and cables, and the sonar can pick up aerators. Use caution 

when routing the transducer cable around these wires. 

If you need to drill a hole in the transom to pass the connector through, 

the required hole size be 1". 
CAUTION: