Lowrance lms-522c igps 操作指南

13 

You can install the sonar and GPS systems in some other order if you 

prefer, but we recommend this installation sequence: 
Caution: 

1. Determine the approximate location for the sonar/GPS unit, so you 

can plan how and where to route the cables for the antenna, transducer 

and power. This will help you make sure you have enough cable length 

for the desired configuration. 
2. Determine the approximate location for the transducer and its cable 

route. 
3. Determine the approximate location for the GPS antenna module 

and its cable route. 
4. Determine the location of your battery or other power connection, 

along with the power cable route. 
5. Install the transducer and route the transducer cable to the so-

nar/GPS unit. 
6. Install the GPS antenna and route the antenna cable to the so-

nar/GPS unit. 
7. Install the power cable and route it to the sonar/GPS unit. 
8. Mount the sonar/GPS unit to the bracket. 

These instructions will help you install your Skimmer

® 

transducer on a 

transom, on a trolling motor or inside a hull. These instructions cover 

both single- and dual-frequency Skimmer transducers. Please read all 

instructions before proceeding with any installation. 
The smaller single-frequency Skimmers typically use a one-piece, 

stainless steel mounting bracket. The larger dual-frequency Skimmers 

typically use a two-piece, plastic mounting bracket. The trolling motor 

mount uses a one-piece plastic bracket with an adjustable strap. 
These are all "kick-up" mounting brackets. They help prevent damage 

if the transducer strikes an object while the boat is moving. If the 

transducer does "kick-up," the bracket can easily be pushed back into 

place without tools.