Lowrance lms-522c igps 操作指南

15 

at speeds faster than 35 mph. Typically, a good transom location on 

aluminum boats is between the ribs closest to the engine. 

3. The transducer should be installed with its face pointing straight 

down, if possible. For shoot-thru applications: Many popular fishing 

boat hulls have a flat keel pad that offers a good mounting surface. On 
vee hulls, try to place the transducer where the deadrise is 10

° or less. 

   

 

4. If the transducer is mounted on the transom, make sure it doesn't 

interfere with the trailer or hauling of the boat. Also, don't mount it 

closer than approximately one foot from the engine's lower unit. This 

will prevent cavitation (bubble) interference with propeller opera-

tion. 

5. If possible, route the transducer cable away from other wiring on the 

boat. Electrical noise from engine wiring, bilge pumps and aerators 

can be displayed on the sonar's screen. Use caution when routing the 

transducer cable around these wires. 

 

How low should you go? 
For most situations, you should install your Skimmer transducer so 

that its centerline is level with the bottom of the boat hull.  

°