Extreme 10808 安装指南
I/O Modules
Extreme Networks Consolidated XOS Hardware Installation Guide
121
I/O Modules
This section describes the BlackDiamond 8810 switch I/O modules, including:
●
●
●
●
No configuration information is stored on the I/O modules; all configuration information is stored on
the MSM(s).
the MSM(s).
When the BlackDiamond 8810 switch is powered on, the software generates a default configuration for
any slots that contain I/O modules. The default configuration allows the I/O module ports to
participate in the VLAN named default. The default configuration for the I/O module is not preserved
unless you explicitly save the configuration to NVRAM.
any slots that contain I/O modules. The default configuration allows the I/O module ports to
participate in the VLAN named default. The default configuration for the I/O module is not preserved
unless you explicitly save the configuration to NVRAM.
You can configure parameters of the I/O module after it is installed or you can preconfigure a slot for a
certain type of module and configuration. The preconfigured information is applied to the module after
it is inserted. If you preconfigure a slot for a specific module type and then insert a different type of
module, the module reverts to its default configuration.
certain type of module and configuration. The preconfigured information is applied to the module after
it is inserted. If you preconfigure a slot for a specific module type and then insert a different type of
module, the module reverts to its default configuration.
NOTE
See the ExtremeWare XOS Concepts Guide and the ExtremeWare XOS Command Reference Guide for more
information about configuring the modules.
information about configuring the modules.