3com S7906E 参考指南
1-29
Note that IPv6 multicast routing must be enabled on the device before this command can take effect.
Related commands: multicast ipv6 routing-enable (IPv6 Multicast Routing and Forwarding
Commands in the IP Multicast Volume).
Examples
# Enable IPv6 multicast routing and enter IPv6 PIM view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] pim ipv6
[Sysname-pim6]
pim ipv6 bsr-boundary
Syntax
pim ipv6 bsr-boundary
undo pim ipv6 bsr-boundary
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the pim ipv6 bsr-boundary command to configure an IPv6 PIM domain border, namely a
bootstrap message boundary.
Use the undo pim ipv6 bsr-boundary command to remove the configured IPv6 PIM domain border.
By default, no PIM domain border is configured.
Related commands: c-bsr; multicast ipv6 boundary (IPv6 Multicast Routing and Forwarding
Commands in the IP Multicast Volume).
Examples
# Configure VLAN-interface 100 as a PIM domain border.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 bsr-boundary
pim ipv6 dm
Syntax
pim ipv6 dm
undo pim ipv6 dm