3com S7906E Guía De Referencia

 

1-29 

Note that IPv6 multicast routing must be enabled on the device before this command can take effect.  

Related commands: multicast ipv6 routing-enable  (IPv6 Multicast Routing and Forwarding 

Commands in the IP Multicast Volume).  

# Enable IPv6 multicast routing and enter IPv6 PIM view.  

<Sysname> system-view 

[Sysname] multicast ipv6 routing-enable 

[Sysname] pim ipv6 

[Sysname-pim6] 

Interface view 

2: System level 

None 

Use the pim ipv6 bsr-boundary command to configure an IPv6 PIM domain border, namely a 

bootstrap message boundary.  

Use the undo pim ipv6 bsr-boundary command to remove the configured IPv6 PIM domain border.  

By default, no PIM domain border is configured. 

Related commands: c-bsr;  multicast ipv6 boundary  (IPv6 Multicast Routing and Forwarding 

Commands in the IP Multicast Volume).  

# Configure VLAN-interface 100 as a PIM domain border.  

<Sysname> system-view 

[Sysname] interface vlan-interface 100 

[Sysname-Vlan-interface100] pim ipv6 bsr-boundary