Xerox 4112 用户指南
Xerox 4112/4127 Copier/Printer System Administration Guide
5-13
5. Using the Scan Service
Configuration of the Job Flow
The following is the procedure to use the job flow scan function:
•
•
Enabling the port and setting TCP/IP
Enable the SOAP port, SNMP port, and Internet service port,
Enable the SOAP port, SNMP port, and Internet service port,
and set IP addresses on the machine.
•
Configuring the SNMP port
Configure the transport protocol for the SNMP port using
Configure the transport protocol for the SNMP port using
CentreWare Internet Services.
•
Configuring the computer
Enabling the ports and setting the IP addresses
In order to use the job flow service, enable the SOAP port, SNMP
port, and Internet service port, and set IP addresses. The
procedure for setting the machine follows.
NOTE: The configuration can also be performed using
CentreWare Internet Services.
CentreWare Internet Services.
Refer to
1.
Enter the System Administrator Mode (Chapter 1 Entering the
System Administrator Mode on page 1-15
System Administrator Mode on page 1-15
)
2.
Enable the SOAP port.
a. Select
a. Select
System Settings
.
b. Select
Connectivity & Network Setup
.
c. Select
Port Settings
.
d. Select
SOAP
and then select
Change Settings
.
e. Select
Port Status
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
g. Select
Close
3.
Enable the SNMP port.
a. Select
a. Select
Network Settings
.
b. Select
Port Settings
.
c. Select
SNMP
and then select
Change Settings
.
d. Select
SNMP - Port
and select
Change Settings
.
e. Select
Enable
and then select
Save
.
f. Select
Close
.