Xerox 4112 用户指南
Xerox 4112/4127 Copier/Printer System Administration Guide
5-11
5. Using the Scan Service
Overview
This section describes the configuration procedure to use the
scanner (save to a computer) function on the machine.
The following is the procedure to use the scanner (save to a
The following is the procedure to use the scanner (save to a
computer) function:
•
•
Enabling the port and setting TCP/IP
Enable the FTP port or SMB port and set the machine's IP
Enable the FTP port or SMB port and set the machine's IP
address.
•
Preparing a FTP folder or SMB folder
Create a folder for transmission destinations on the computer.
Create a folder for transmission destinations on the computer.
NOTE: When using with SMB protocol, you must login to the FTP
server of your choice and create a destination directory for your
files.
server of your choice and create a destination directory for your
files.
Enabling the ports and setting the IP addresses
In order to use the scanner (save to a computer) service, enable a
port (SMB or FTP client) and set the IP address. The procedure
for setting the machine is as follows:
NOTE 1: The configuration can also be performed using
CentreWare Internet Services.
CentreWare Internet Services.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
1.
Enter the System Administrator Mode (Chapter 1 Entering the
System Administrator Mode on page 1-15
System Administrator Mode on page 1-15
)
2.
Enable the SNMP port.
a. Select
a. Select
System Settings
.
b. Select
Connectivity & Network Setup
.
c. Select
Port Settings
.
d. Select
SMB
and then select
Change Settings
.
e. Select
Port Status
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
g. Select
Close
3.
Enable the FTP client port and Internet service (HTTP) port as
above.
above.
4.
Select
Close
.
5.
If necessary, set the IP Address (Chapter 1 Setting the IP
address. on page 1-17).
address. on page 1-17).