Xerox 4260s 用户手册

Follow these instructions to connect the machine to an Ethernet TCP/IP network.

If you are connecting your machine to a different type of network, or you wish to use 
other protocols, refer to the System Administration CD.

Before connecting the machine to your network, make sure that it is operating 
correctly as a copier.

Place a document in the Document Feeder and make 3 copies.

If the copies are made successfully, install the network connection as described in 
the next steps. If copying is not successful, refer to Troubleshooting on page 33.

You can set up the TCP/IP network connection using either of the following methods:

•

DHCP: Use this method to allow a DHCP server to automatically assign an 
IP address. This is the factory default setting.

•

Static IP address: Use this method to manually assign an IP address 
provided by the network administrator.

When the machine is powered on, it automatically uses DHCP to obtain its network 
configuration. To use a static IP address, DHCP must be turned off and the IP address, 
gateway address, subnet mask, and DNS Server address must be entered manually.

Connect the Ethernet cable to the RJ45 
connector on the back of the machine. 

To setup the address using DHCP, see 
Network Setup Using DHCP on page 10

. If 

you want to set a static IP address, skip to 
Network Setup Using a Static IP Address 
on page 11

After the machine starts, it negotiates with the DHCP server for an IP address. Wait 
two minutes for the network setup to complete and then check the allocated IP 
address as follows:
•

On the Control Panel, press the Log In/Out button and then enter the 
Administrator’s Password [1111] and select Enter.

RJ45 
Network 
Connector