Xerox 7500DT 用户指南
Network Basics
Phaser 7500 Color Printer
User Guide
45
UNIX (Linux)
Your printer supports connection to a variety of UNIX platforms through the network interface. The
workstations currently supported by CentreWare for UNIX/Linux to a network-connected printer are:
workstations currently supported by CentreWare for UNIX/Linux to a network-connected printer are:
•
Sun Solaris
•
IBM AIX
•
Hewlett-Packard HP-UX
•
Linux (i386)
•
Linux (PPC)
The following procedures enable you to connect your printer using any of the supported versions of
UNIX or Linux listed above.
UNIX or Linux listed above.
Quick Install Steps
Perform the following procedures to set up the printer and install the appropriate drivers.
From the Printer
To set up the printer:
1. Verify that both TCP/IP protocol and the proper connector are enabled.
2. On the control panel, select one of these IP address options:
•
Allow the printer to set up a DHCP address.
•
Enter the IP address manually.
3. Print the Configuration page and keep it for reference.
From Your Computer
To install the printer:
1. Go to
2. Select
Unix from the Operating System drop-down menu, and then click Go.
3. Click the CentreWare for Unix package for the operating system this will be installed in. This is the
core package and must be installed first before the printer package.
4. Click the
Start button to begin downloading.
5. Repeat steps 1 and 2, and then click the
Printer Package for use with CentreWare for Unix link.
6. Click the
Start button to begin downloading.
7. In your browser, click the
Installation Guide link, and then follow the installation instructions.
Note:
If print-quality problems exist, or your job did not print, access PhaserSMART Technical
Support through CentreWare IS.