Xerox 5790 参考指南

USAGE GUIDELINES

REGAL 5790 MATERIALS USAGE GUIDE

13

•

When recommended materials are run as detailed above, with 
the correct tray, mode, and orientation,  feeding performance 
and image quality is good, but will not equal 24 lb LX (90 gsm) 
performance. 

•

The Xerox 1-up (3R4473) and 8-up (3R4472) labels may 
experience more jams due to their higher stiffness.

•

Toner saturation on electronic originals should be limited to a 
total of 280%  (70% for each Color).  Higher toner saturations 
can result in poorly fused prints.

•

In general, successful labels will have a low-weight face and 
backing sheet, and should have a pattern-printed adhesive.  
Overall weight should be less than 163 gsm.  They should also 
be run with the grain parallel to the leading edge.

•

If attempting to use a label that has not been recommended,  
first try a small quantity to test its performance, then consult 
your local Xerox representative for agreement on its use. 

CAUTION:  Dry gum labels (those that require moistening before 
being applied) can cause severe machine contamination problems 
and should not be used.

Coated papers have binders, adhesives and pigments applied to 
their surfaces on one or both sides.  As compared to the primary 
24lb (90 gsm) papers, they provide improved image gloss but will 
generally cause an increase in jams.  Two-sided copying/printing of 
coated papers is not recommended because of frequent jams and 
likely image quality/gloss problems.

  8.5 x 11” =  3R5093

  11 x 17”  =  3R5094

  8.5 x 11” = 3R5095

  11 x 17”  = 3R5096

These Xerox Coated papers are specifically made for use in 
copiers/printers. Because of wide variation in other coated 
papers, it is  impossible to predict how they will perform.