Xerox N2825 安装指导
OS/2 Warp V4.0 and OS/2 Warp Connect 3.0 Peer-to-Peer Network
38
❖
Quick Network Install Guide
OS/2 Warp V4.0 and
OS/2 Warp Connect 3.0
Peer-to-Peer Network
OS/2 Warp Connect 3.0
Peer-to-Peer Network
Quick Install Steps
1
Print the Configuration Sheet. Details are in this
document in Appendix A: Print The Configuration
Sheet.
document in Appendix A: Print The Configuration
Sheet.
2
Check the Configuration Sheet and verify that both
TCP/IP protocol and proper connector are enabled on the
printer.
TCP/IP protocol and proper connector are enabled on the
printer.
3
Create a new printer to load print drivers. Details for this
are found in the Technical Information Guide.
are found in the Technical Information Guide.
4
Create a printer share and its access permissions (sharing
and connecting).
and connecting).
5
Start LPRPORTD/LPRMON, ping printer, open EPM and
send a print job to the printer.
send a print job to the printer.
6
Check the print job for print quality. If print quality
problems exist, use the print quality section of your
printer System Administrator Guide to correct the
problem.
problems exist, use the print quality section of your
printer System Administrator Guide to correct the
problem.
7
If your print job did not print, see the Troubleshooting
section for your operating system in the Technical
Information Guide to correct the problem.
section for your operating system in the Technical
Information Guide to correct the problem.